Pro Roofing Cypress
Gutter Replacement

Gutter replacement Cypress CA built to handle real winter rain

When your old gutters sag, leak at the seams, or dump water against the foundation, gutter replacement Cypress CA homeowners trust is the fix that lasts. We remove the failing run, inspect the fascia, and hang new seamless gutter sized to your roofline and pitch. Most Cypress homes are single-story or two-story stucco builds with tile or asphalt shingles, and we match the gutter profile to both. Free estimate, usually within a day.

Service overview

What gutter replacement Cypress CA actually involves

Gutter replacement Cypress CA is the full removal and re-hanging of your rain gutter system, not a patch job on one leaking seam. We pull the old sections down, check the fascia board and soffit for rot behind them, then fabricate new seamless runs on site with a gutter machine. Hangers go into the rafter tails or fascia every 24 inches, and every run gets the correct slope toward the downspouts so water moves instead of sitting. Downspouts, elbows, and splash blocks are sized to the roof area they drain. Cypress sits in Orange County, where we get long dry stretches followed by concentrated winter storms. That cycle is hard on gutters. Aluminum expands in summer heat, seams open, and the first heavy rain finds every gap. Homes built in the 1960s through the 1980s around Cypress often still have original 4-inch gutter that was undersized for the roof even when it was new. If you are searching for gutter replacement in Cypress CA near me because water is pooling at the slab, we can usually get out and look within a day or two.

! Common warning signs

Gutter overflowing at the edge during rain

Water sheets over the front lip and lands right at your foundation. Over a season, that can mean cracked stucco, a wet crawlspace, and soil erosion around the slab.

Gutter pulling away from the fascia

Sagging gutter holds standing water, which rusts the hangers and rots the fascia board behind it. Left alone, the whole run can come down in a windstorm and take the drip edge with it.

Leaking seams and stained stucco

Every seam is a potential leak. Water dripping behind the gutter stains the stucco, soaks the fascia, and eventually finds its way into the wall. It looks bad and it is doing damage you cannot see.

Scope of work

What is included in a gutter replacement

Every gutter replacement we do includes tear-off, fascia inspection, new seamless gutter, new hangers, downspouts, and a water test. If we find rot or damaged flashing behind the old gutter, we tell you before we start and quote the repair so there are no surprises on the invoice.

  • 01

    Tear-off and haul away

    We remove the old gutter, downspouts, and hangers, then haul everything off site. The roof edge gets cleared of loose granules and debris so the new hangers seat flat against clean wood or fascia.

  • 02

    Fascia inspection and repair

    Once the old gutter is down, we check the fascia board and soffit for soft spots and rot. Rotted sections get replaced before we hang anything new, because a gutter screwed into soft wood will pull loose within a season.

  • 03

    Seamless gutter and hangers

    We fabricate seamless aluminum, copper, or steel gutter on site to your exact run length. Hangers go in every 24 inches, screwed into the fascia or rafter tails, and each run is pitched about a quarter inch per 10 feet toward the downspouts.

  • 04

    Downspouts and water test

    Downspouts are sized to the roof area they drain, with elbows and splash blocks to move water away from the foundation. When the install is done, we run water through the whole system and fix anything that weeps before we leave.

Why homeowners replace instead of patch

Patching a gutter that has already failed in three places usually buys you one more season. Replacing the run solves the slope, the hangers, and the capacity problem at the same time, and it stops the water damage that starts at the fascia and works inward.

Book a free estimate

Tools and methods we use on every job

Seamless gutter machine

Fabricates the gutter run on site to your exact measurements, so the system has far fewer seams than pre-cut box store sections. Fewer seams means fewer leak points.

Tin snips and utility knife

Used to cut and trim gutter sections, downspout ends, and flashing at corners and outlets. Clean cuts mean the joints seal properly the first time.

Power drill and caulking gun

Drives the hidden hangers into the fascia or rafter tails and applies roofing caulk at corners, outlets, and end caps. Properly sealed joints are what keep a gutter system dry.

Roofing ladder and chalk line

The ladder gets us safely to the roof edge, and the chalk line marks the pitch so every run slopes consistently toward the downspouts instead of holding water.

Local execution

Cypress sits in Orange County, where the climate swings from hot, dry summers to concentrated winter rain. That cycle is hard on gutter. Aluminum expands in the summer heat, seams open, and the first heavy storm finds every gap. Most homes here were built between the 1960s and 1980s with 4-inch gutter that was undersized even when it was new. We replace it with 5-inch or 6-inch seamless aluminum, copper, or steel, sized to the actual roof area draining into each run. Because Cypress lots are tight, we plan the downspout layout carefully so water discharges away from the foundation and not into the neighbor's yard. If you are looking for rain gutter replacement Cypress California homeowners recommend, we can usually measure and quote within a day or two. We work around stucco walls, tile roofs, and mature landscaping, and we leave the site swept clean.

How gutter replacement runs in Cypress

  • • Cypress Village
  • • Lincoln Avenue corridor
  • • Valley View area
  • • Ball Road neighborhood

Recent work

150 feet of sagging aluminum replaced [ A single-story Cypress home had original 4-inch aluminum gutter sagging away from the fascia. Seams leaked at every joint, and the stucco below was stained with drip lines. Two sections of fascia board were soft enough that the hangers had pulled out completely. ]
Commercial edge gutter and four downspouts [ We replaced the full run with 6-inch seamless aluminum over two days, working around tenant hours. Four new downspouts were installed and routed to the lot drainage. The water test confirmed the system handled a full-flow test without overflowing. ]
A minimalist photo of a red wall with a white rain gutter, showing clean lines and vibrant color contrast.
Always available
Always available

Gutter replacement Cypress CA 24/7 when storms hit

When your gutter fails, we answer

When a winter storm pulls your gutter away from the fascia or a downspout comes loose and starts dumping water at the foundation, you do not want to wait until next week. We take emergency calls 24/7 across Cypress and the surrounding Orange County cities. Our trucks carry the hangers, caulk, downspout parts, and tools to secure a failing run the same day, and we schedule the permanent replacement as soon as the weather allows. Typical emergency response in Cypress is within a few hours during storm season. For non-emergency work, we can usually get out to measure and quote within a day or two. Call and tell us what you are seeing, and we will tell you honestly whether it can wait or needs attention now.

24/7
Emergency availability

How our gutter replacement process works

1

On-site measure

We walk the roof edge, measure total run length, count downspout drops, and check the fascia and soffit for soft spots. You get a written scope the same day with the gutter profile, material, color, and downspout layout spelled out. This visit takes about 30 to 45 minutes.

2

Material and color

You pick from standard aluminum colors, or we order copper or steel if you want a specific look. We confirm the gutter size, either 5-inch or 6-inch, based on your roof area and pitch. Most Cypress homes land on 5-inch aluminum with a matching downspout.

3

Tear-off and prep

On install day the crew removes the old gutter and downspouts, hauls them off, and inspects the fascia board underneath. Any rotted sections get replaced before we hang anything new. We also clear the roof edge of loose granules and debris so the new hangers seat clean.

What gutter replacement costs in Cypress

Gutter replacement in Cypress runs $1,400 to $3,800 for most homes in 2026, with the typical single-story job landing between $1,800 and $2,600. The price depends on total run length, gutter material, and how much fascia repair is needed. We measure on site, give you a firm written price, and that number does not move unless you add work. If you are comparing quotes from a Cypress CA gutter replacement contractor, ask whether fascia repair and downspout replacement are included.

01

Total run length

Gutter is priced by the linear foot, so a 120-foot run costs less than a 220-foot run. Two-story homes and complex rooflines with multiple valleys and corners take more material and more labor, which raises the total.

02

Gutter material

Standard aluminum is the most affordable and the most common choice in Cypress. Copper and steel cost more but last longer and hold their appearance. The material you pick can swing the price by several hundred dollars on a typical home.

03

Fascia and soffit repair

If the fascia board behind the old gutter is rotted, it has to be replaced before the new gutter goes up. The amount of rot varies from home to home. We inspect during the quote and include the repair in the price so there are no surprises.

Licensed, insured, and accountable

"Pro Roofing Cypress replaced about 160 feet of gutter on our house in Cypress. They found rotted fascia behind the old gutter and fixed it the same day. Clean work, fair price, and the new seamless gutter looks great. No leaks after the first rain." — Google

Gutter replacement questions

How much does gutter replacement cost in Cypress CA?

Most residential gutter replacements in Cypress run $1,400 to $3,800 in 2026, depending on total run length, gutter material, and how much fascia repair is needed. A typical single-story home with 150 to 180 feet of gutter lands in the $1,800 to $2,600 range for 5-inch seamless aluminum. Copper and steel cost more. We give you a firm written price after the on-site measure.

Who replaces rain gutters in Cypress California?

Pro Roofing Cypress replaces rain gutters across Cypress and the surrounding Orange County cities. We have been in business since 2000, hold a California Contractor License C-39, and fabricate seamless gutter on site. We handle the tear-off, fascia repair, new gutter, downspouts, and the water test. Call us and we will come measure and quote the job.

How long does gutter replacement take in Cypress CA?

Most single-family gutter replacements take one day, usually six to eight hours for a typical Cypress home with 150 to 200 feet of gutter. Larger homes, two-story runs, or jobs with significant fascia rot can stretch to two days. We tell you the expected duration when we give you the quote, and we do not leave a job half-finished overnight.

Do you offer gutter replacement near me in Cypress?

Yes. We serve all of Cypress, ZIP code 90630, plus the surrounding cities of Los Alamitos, La Palma, Buena Park, Cerritos, and Westminster. If you are in or near Cypress, we can usually get out to measure within a day or two. Call and we will schedule a free estimate at a time that works for you.

!

Get your gutter replacement Cypress CA quote today

We will come out, measure the run, check the fascia, and give you a firm written price. Most quotes are done within a day of your call. If your gutter is already overflowing or pulling away from the house, tell us on the phone and we will prioritize it.

Call Now: 345665767